All About Your Water:
Who: Your drinking water is regulated by the Environmental Protection Agency (EPA), who sets drinking water quality standards, establishes testing methods and monitoring requirements for water utilities, sets maximum levels for water contaminants, and requires utilities to give public notice whenever a violation occurs. Your drinking water is tested frequently both by North City Water District and Seattle Public Utilities, our supplier, to ensure that high quality water is delivered to your home.
What: Drinking water, including bottled water, may reasonably be expected to contain at least small amounts of some contaminants. The presence of contaminants does not necessarily indicate that water poses a health risk. More information about contaminants and potential health effects can be obtained by calling the Environmental Protection Agency’s (EPA) Safe Drinking Water Hotline 800.426.4791.
When: Your water is continuously monitored 365 days a year.
Where: Your water comes from both the Tolt and Cedar River Watersheds.
How: Last year your drinking water was tested for over 200 compounds and additional contaminates. Tests are done before and after treatment and while your water is in the distribution system. The Tables presented on the following page list all of the contaminants detected in the most recent required water testing and compare them to the limits and goals set by the EPA and the State of Washington to ensure your tap water is safe. Not shown are more than 200 additional contaminants that were tested for, but not detected, in your drinking water. If you would like to see a list of these other compounds or if you have other water quality questions, do not hesitate to contact us. Please note: asbestos monitoring is not required for our District because all the asbestos pipe in our distribution system was replaced prior to 1991.
The Best News: Your water falls safely within state and federal guidelines for each and every contaminant, significantly below the EPA’s levels.
Lead and Copper Monitoring Results:
Our regional water supply does not contain lead or copper. However it is possible that lead levels at your home may be higher than at other homes in the community as a result of materials used in your home’s plumbing.
If present, elevated levels of lead can cause serious health problems, especially for pregnant women and young children. Lead in drinking water is primarily from materials and components associated with service lines and home plumbing. North City Water District is responsible for providing high quality drinking water, but cannot control the variety of materials used in plumbing components.
When your water has been sitting for several hours, you can minimize the potential for lead exposure by flushing your tap for 30 seconds to 2 minutes before using water for drinking or cooking. If you are concerned about lead in your water, you may wish to have your water tested. Information on lead in drinking water, testing methods, and steps you can take to minimize exposure is available by calling the EPA’s Safe Drinking Water Hotline at 1.800.426.4791, or visit their website at: www.epa.gov/safewater/lead.
People With Special Concerns:
Some people may be more vulnerable to contaminants in drinking water than the general population. Immunocompromised persons such as persons with cancer undergoing chemotherapy, persons who have undergone organ transplants, people with HIV/AIDS or other immune system disorders, some elderly, and infants can be particularly at risk from infections. These people should seek advice about drinking water from their health care providers. EPA/Centers for Disease Control (CDC) guidelines on appropriate means to lessen the risk of infection by Cryptosporidium and other microbial contaminants are available from the Safe Water Drinking Hotline 1.800.426.4791. If you would like to learn more about your water, or if you have questions about its quality, please don’t hesitate to contact North City Water District at (206) 362-8100.